Exo Terra REPTI CLEAR F150 Manual De Instrucciones página 6

* It is not recommended to rinse the foam directly in tap or
well water, as the water contains chemicals that make it
unsafe to reptiles and amphibians. As a precaution, the foam
should always be rinsed in de-chlorinated water. To do this,
fill a container with water and then treat the water with a
water conditioner such as Exo Terra Aquatize to neutralize the
chemicals. Once the water has been de-chlorinated, you can
then rinse the sponge.
** Replacement Filter Foam (PT-2096) can be purchased from your
local Exo Terra dealer or pet retailer.
Note:
If you are using well water, or if you have hard water, run the filter
for a few minutes in a 50/50 solution of water and vinegar to help
remove calcium deposit buildup. Rinse filter thoroughly before
replacing it in the terrarium.
Caution:
Do not use detergents or other chemical cleaners. The power cord
cannot be replaced, discard the appliance if damaged.
6
IMPELLER WELL
FILTER
Troubleshooting:
Caution:
The filter must not be allowed to run dry. If filter fails to operate,
check the following:
No Flow:
• Check if the power supply is on. Check the circuit breaker or
try another outlet to ensure the filter is getting electrical power.
Note: always disconnect the filter from electrical supply before
handling.
• If power supply is working but filter is not, then it may be
clogged by debris. Disconnect the filter, check intake screen to
ensure it is not clogged, then follow the maintenance procedures
to clean impeller.
Low Flow:
• Check the filter's intake screen to ensure it is not clogged by
debris. Then follow the maintenance procedures to clean impeller
IMPELLER COVER
IMPELLER
FOAM
INTAKE SCREEN