Troubleshooting; Technical Data - OK. OSI 3211 Manual De Instrucciones

SELF CLEAN FUNCTION
The self clean function cleans the product of impurities. Cleaning with the self clean system should be
carried out as follows before the first use, after longer periods of disuse or every 10 to 15 days:
Fig. 16 Unplug the power plug from the power outlet.
Put the steam control knob to the 0 position.
Fig. 17
Fill the water tank to the max mark.
Fig. 18
Put the product onto its stand base.
Fig. 19
Connect the power plug to a suitable power outlet. Disconnect from the power outlet as soon
Fig. 20
as the temperature control lamp turns off.
Fig. 21 Set iron to the maximum temperature.
Hold the device in a horizontal position over a sink. Press on self clean and continue pressing.
Fig. 22
Gently move the device back and forth until damp and hot water cease to escape.
Fig. 23
Fig. 24 Shake out any remaining water out of the water fill opening. Once the soleplate has cooled
down, it can be cleaned with a damp cloth.
Caution: Do not put any vinegar or other decalcifying agents into the water tank.

TROUBLESHOOTING

If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem
Water droplets escape
from the soleplate

TECHNICAL DATA

Rated voltage
Rated input power
Rated frequency
DISPOSAL
Do not dispose of this product as unsorted municipal waste. Return it to a designated collection
point for the recycling of WEEE. By doing so, you will help to conserve resources and protect the
environment. Contact your retailer or local authorities for more information.
IM_OSI3211_161206_V02_HR.indb 17
Possible causes
• After stopping steam ironing
condensed water drops can be
ejected when continuing steam
ironing.
• Ironing temperature is too low.
: 220 - 240 V~
: 2000 - 2400 W
: 50/60 Hz
17
Solution
• It is not a malfunction.
• To avoid droplets when
continuing steam ironing, do
not hold the soleplate over the
garment until regular steam
escapes.
• Steam ironing and steam jet
function are only available at a
higher temperature setting (
and above).
• Adjust to a suitable temperature
or switch off the steam function.
EN
9/12/16 8:50 AM