Automatic Charging - Samsung POWERbot Manual Del Usuario

Steps to take if recharging not occuring:
Check the installation status of the
docking station when:
fthe docking station is located in a place where the
POWERbot cannot easily access it.
fthe distance between the docking station and
POWERbot is over 20 ft (5 m)
- It may take a long time for POWERbot to return to
the docking station for recharging

automatic charging

recharging
Low battery (Lo)
ENGLISH-13
When the battery indicator blinks
during cleaning, the poWerbot
will return to the docking station to
charge itself automatically.
you can command the poWerbot
to recharge at the docking station
while it is in cleaning.
manually charge the poWerbot by
placing it on the docking station.
manually charge the poWerbot when:
fthe docking station is located in a corner
fthe battery is fully exhausted
fthe POWERbot is immobilized by an obstacle
(furniture etc.)
fthe POWERbot can't climb a threshold near the
docking station (The maximum height of a threshold
the POWERbot can climb is about 0.6 in (1.5 cm)).
fwhen the battery indicator blinks and "Lo" is
displayed
fwhen the POWERbot is set to the Spot clean or
Manual clean mode