Gb User Manual - Puky Z2 / ZL 12 Manual De Instrucciones

On long slopes, long periods of braking with
the back pedal brake are to be avoided
(excess heat to the back pedal brake nave).
The valve caps must be firmly tightened and
kept out of reach of children (risk of choking).
Subsequent additions or modifications to the
bicycle (especially the braking systems) will
change the behaviour of the vehicle and may
pose a risk.
Do not use any sharp objects when opening
the packaging and removing protective materi­
al. If you were to do so, you may damage the
paint or parts of the bike.
Keep all packaging material out of reach of
children.
z Remove all parts from the packaging.
z Remove the protective material.
z Examine the package for completeness and
proper condition. If anything is missing,
please contact your dealer before you con­
tinue to assemble the bike.
1. Bike preassembled
2. Handlebar preassembled
3. Pedals and User Manual in a plastic bag,
for 3­gear models: Additional gear stick
4. Unpacking and scope of delivery
The delivery consists of (Figure A):
User Manual
13
Prepare for use by adjusting to the height of
the child. The saddle is to be set so that at
least the toes, preferably the ball of the foot,
reach the ground in order to ensure balance
can be achieved when at a standstill. In doing
so, the marking showing the minimum inser­
tion depth on the saddle post into the frame
tube must be observed. For more information,
see below.
The handlebar, hand brake lever and bell must
be easy for the child to reach from the set sad­
dle position.
In doing so, the marking showing the minimum
insertion depth of the handlebar shaft must be
observed. After adjusting the handlebar, tight­
en the clamping screws firmly. Use the follow­
ing safety checklist to check the bicycle be­
fore using.
When mounting the pedals, observe the right
and left threads (labelled on the pedal axis
with an R or L in the vicinity of the thread).
The images for the assembly instructions can
be found on the last pages of this manual.
After assembly, please conduct a safety check
in accordance with the safety checklist!
During assembly, please note that some parts,
such as pedal thread and clamping cone are
lubricated.
5. Assembly and first use
GB