PROFLO PFS5838 Manual De Instalación Y Funcionamiento página 7

fRAMING AND INSTALLATION
REfERENcE fOR cORREcT TILE fLANGE INSTALLATION
USE DRAwING bELOw AS A REfERENcE GUIDE fOR ROUGh-IN MEASUREMENTS
SUGGESTED WHIRLPOOL/BATH
SUGGESTED ALCOVE
INSTALLATION METHOD
INSTALLATION METHOD
STUD
WATERPROOF DRYWALL
OR CEMENT BOARD
ROOFING NAIL
SEALANT
TUB
1 X 4 (25mm X 76mm)
WOOD STINGER FULL LENGTH
Allow the mortar material to completely harden before applying weight to the rim or bottom of the bath. Any finish material such as tile or
wall board must be self supporting if it contacts the deck of the bath.
Verify that the product is lever by checking the tub deck surface in all directions.
For system tubs ensure blower and or pump cords are properly plugged into the dedicated 120V/20A GFCI outlet to supply electrical
power to the system (Please reference pg. 6) for electrical requirement information. To test run the bath, fill the tub with water at least 3"
above the highest jet and operate the bath for 5 minutes. Check all bath and piping connections for leaks.
POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Do not use wire brushes or any other metal implement on bath surface.
Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent.
Stubborn dirt or stains may be removed using granular Spic and Span
excess adhesives and/or wet oil-base paint.
PROFLO.COM
TYPICAL DROP-IN TYPE INSTALLATION
AS DESIRED
F
CUTOUT
C
AS DESIRED
MOUNTING
SURFACE
WATERPROOF
SEALANT
BATH
UNLESS AS ACCESS OPENING OF AT LEAST 18" X 24" UNLESS AS ACCESS OPENING OF AT LEST 18" X 24"
IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED. IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED.
TILE
G
CUTOUT
18"
(457.2MM)
24"
(609.6mm)
ACCESS PANEL MUST BE LOCATED
ON THE SAME SIDE AS THE MOTOR.
ALLOW OPEN FRAMING ON
PUMP MOTOR END FOR SERVICE.
ACCESS PANELS NOT REQUIRED
FOR NON-SYSTEM TUBS.
DRAIN CLEARANCE
11"
12"
mixed with water. Painter's Naphtha can be used to remove
®
UNLESS AS ACCESS OPENING OF
IS PROVIDED, WARRANTY SERVIC
REFERENCE FOR DROP-IN INSTA
WALLBOARD
AIR GAP 1/4" OR MORE
STUD
PUMP ACCESS
FOR NO
TILE
SILICONE
1" X 4" JO
7