Cleaning And Maintenance - Weidmuller MCP Plus 2 Manual De Instrucciones

7

Cleaning and maintenance

7.1 Cleaning the plotter
ATTENTION
Risk of damage to plotter!
Solvents and abrasive detergents can damage the
surface of the plotter.
► If required, use only the detergents recommended
as accessories.
► Never oil the mechanical parts of your plotter!
► Protect the plotter from dust and other contamina-
tion. Cover the plotter when not in use.
A cover is available as an accessory (see Chapter 10).
► Clean the plotter with a dry cloth after use.
► If necessary, use a damp cloth and a mild detergent.
► Replace the seal inserts in the pen station if they
are very dirty.
There is a replacement seal insert in the service pack
(see Chapter 10).
7.2 Replacing the seal insert
The service pack contains a new seal insert and a tool
key.
The plotter must be switched on.
► Open the pen station.
► Fit the tool key to the seal insert.
Fig. 7.1 Fitting the tool to the seal unit
30
► Carefully lift the seal insert upwards out of the
holding fixture.
Fig. 7.2 Removing the seal insert
► Place the new seal insert in the holding fixture and
press it down carefully until it clicks into place.
Fig. 7.3 Fitting the seal insert
► Use the tool key to align the seal insert so that the
opening points centrally towards the writing area
(the key is parallel to the plotting surface).
Fig. 7.4 Aligning the seal insert
4326440000/04/12.2016