Before First Time Use - OK. Oht 103 Manual De Instrucciones

EN

BefORe fIRST TIme USe

• After unpacking, clean the product (
• Run the product 2 or 3 times. Then switch off the product and let it cool
completely.
OpeRATION
Connecting to power: Connect the power plug to a suitable electrical
1
outlet.
Switching appliance on: Slide the ON/Off switch to the ON position.
2
Switching appliance off: Slide the ON/Off switch to the Off position.
After use: Unplug the appliance and place it on a heat-resistant surface to
3
let it cool.
Shorter cutting length: Press the lever upwards. In the upmost lever
4
position, you can obtain the closest cut that leaves the hair very short.
Longer cutting length: Press the lever downwards.
Warning!
• Set the ON/Off switch to the Off position when connecting the power
plug to the power outlet.
• Do not touch the blade during operation.
Hints for cutting hair
Hold the appliance with the cutting edge facing upwards. Start on the
5
bottom of the neck and work towards the middle of the head. Gently put
the appliance on the skin and move it in an up and outwards direction.
Repeatedly lift the appliance away from the head. Cut only a small amount
of hair each time.
Hold the appliance at the desired angle to trim the hair on the sides.
6
Move the appliance around the side hair in the angle desired to finish side
7
cutting.
With the blade teeth of the appliance flat against the hair on top of the
8
head, slowly cut the hair against the direction of hair growth.
Adjust the blade to a close-cut position ( Cutting length). Trim the hair on
9
the neck, sides and around the ears to outline the hair.
Using the attachment combs
With the different attachment combs (3, 6, 9, 12 mm), you can achieve desired
cutting length.
Select desired attachment comb. Attach it to the clipper head in place.
10
OHT103_140716_V08.indb 16
16
Cleaning and care).
7/16/14 10:01