Intended Use; On/Off Switch - OK. Oht 103 Manual De Instrucciones

Do not pull the power plug out of the electrical outlet by the power cord and
24.
do not wrap the power cord around the appliance.
Connect the power plug to an easily reachable electrical outlet so that in case
25.
of an emergency the appliance can be unplugged immediately. Pull the power
plug out of the electrical outlet to completely switch off the appliance. Use the
power plug as the disconnection device.
For additional protection, we recommend the use of a residual current device
26.
(RCD) with a tripping current not exceeding 30 mA in the electrical circuit
supplying power to your appliance. The installation should be done by an
experienced electrician.
Disconnect the power plug from the electrical outlet when not in use and
27.
before cleaning.
Should the appliance fall into water, unplug the power plug first before
28.
reaching into the water.
Danger to life! Make sure that no objects like hair clips or hair pins are
29.
inserted into the appliance. These can cause a short-circuit.
Do not use the appliance barefoot.
30.
Do not leave the appliance unattended, if it is in use or the power plug is
31.
connected to an electrical outlet.
During use, do not use hairspray, water vaporisers or other vaporisers close
32.
to the appliance. Only use them when the appliance is switched off and the
power plug is disconnected.
Do not use the appliance if you are sleepy or if there is a possibility that you
33.
will fall asleep.
Store the lubricating oil in a place that is inaccessible to children. Should a
34.
child swallow the oil, contact a doctor immediately.
The small parts can be extremely dangerous if swallowed. Therefore, keep the
35.
appliance and its accessories out of the reach of infants.

INTeNDeD USe

The appliance is only intended for shaving and trimming natural head hair and
beards of humans. Every other type of use can lead to damage to the product or
injury. Do not use it to trim pet fur.
COmpONeNTS
Fold out front and rear page for product illustrations.
A. Blade protector
B. Blades
C. Cutting length adjustment lever
D. ON/Off switch
E. Power cord with plug
OHT103_140716_V08.indb 15
15
Accessories
F. Lubricating oil
G. Cleaning brush
H. Scissors
I. Comb
J. Attachment combs (3, 6, 9, 12 mm)
EN
7/16/14 10:01