Environmental Specification; Protection And Operating Safety; Options; Charger Operation - Cristec CPS Serie Manual Del Usuario

2.1.3.2 Current
The table below defines the maximum output current
at rated output power as well as the type and rating of
the carsocket type fuses placed in series with the
charger outputs.
Maximum
Model output
current
12V 06A 6 A
24V 03A 3 A
12V 10A 10 A
24V 05A 5 A
12V 12A 12 A

2.1.4 Environmental specification

All chargers in the range meet the following
characteristics :
Storage temperature : - 20°C to + 70°C.
Operating temperature : - 10°C to + 50°C.
Humidity : < 90% non-condensing

2.1.5 Protection and operating safety

2.1.5.1 Input protection
The chargers are fitted with two pole protection by 2
fuses F1 and F2 whose ratings are given in section
2.1.2.
2.1.5.2 Output protection
Output protection is provided by a fuse placed in
series with the "–" terminal of the charger in order to
reduce the number of fuses. The rating and type of
this fuse are defined in the table in section 2.1.3.2.
2.1.5.3 Additional safety devices
All models are fitted with the following safety
devices :
Protection against input voltage surges by a
Varistor (275 Vac).
Protection against abnormal heating of the power
semiconductors.
Protection against polarity reversal (output fuse
blows)
Fuse Output
rating type of fuse
25707.5
7,5 A
LITTLEFUSE
257005
5 A
LITTLEFUSE
257015
15 A
LITTLEFUSE
25707.5
7,5 A
LITTLEFUSE
257015
15 A
LITTLEFUSE
CPSDED
Protection against overloads on the output by
limiting the power to the rated value for each
model.
2.1.5.4 Fan Functioning
The chargers do not have any electromechanical fan;
they have a natural ventilation :

2.1.6 Options

The options do not form part of the basic battery
charger supply. They are available from your
reseller. The only extra options that could work with
the CPS chargers are the pieces of equipment
proposed as an option by CRISTEC.
Analogue voltmeter for displaying the charging
voltage at the input side of the charge
distribution diodes.
Model 12 V
Model 24 V
48x48mm analogue ammeter for displaying the
total battery charging (SHUNT already fitted
into the charger PCB)
12V 06A
24V 03A
12V 10A
24V 05A
12V 12A
2.2

CHARGER OPERATION

2.2.1 Output voltage

The charger delivers a voltage suitable for recharging
1 or 2 separate batteries.
Voltmeter
Model
reference
VLT 0012
VLT 0024
Ammeter
Model
reference
AMP 0070/1
AMP 0070/2
AMP 0120/1
AMP 0120/2
AMP 0140/1
Page 15