Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRONIC
CONTROL
SETUP
iNSTRUCTiONS
Washer Control
NOTE: After the washer/dryer
has been installed
and plugged
in, the display will show
"0 MINUTES"
on the washer
and dryer
portions
of the display. After the washer
and dryer doors have
been opened
and closed,
the display will show the price for each
machine.
On washer/dryers
set for free cycles, the display sections
will flash "SELECT
CYCLE'
1. PD Models:
Insert coins until "SELECT
CYCLE"
flashes
on the
display portion
of the washer
or dryer that is to be run.
PN Models:
A debit card is required
rather than coins.
Generation
1 or 2 debit card systems
may be used; but
when the Generation
2 debit system
is used, the controls
will automatically
be set to Enhanced
Debit mode (J. Ed). In
Enhanced
Debit mode, the card balance
will also display when
a debit card is inserted
into the reader.
2. Door must be closed
on the desired washer/dryer
before cycle
selection
is made.
3. Press the fabric setting
button for the washer/dryer
cycle
desired.
After the cycle is started,
the time will display and
count down.
4. If a cycle is interrupted
by opening
the door or power
loss,
"RESELECT
CYCLE"
will flash in the display. To restart the
washer/dryer,
close door and reselect
desired
cycle.
NOTE: When
set for free vend operation
an ongoing
dryer cycle
will cancel
if the door is opened.
Dryer Control
General
Washer/Dryer
User Information
SCROWNG
"OUT OF ORDER" MESSAGE,
FOLLOWED BY A
FAILU RE OR DIAGNOSTIC
CODE, SHOWING
IN DISPLAY - This
condition
indicates
the washer/dryer
is inoperative.
Diagnostic
codes
being displayed
on the upper portion
of the display pertain
to the dryer section,
and diagnostic
codes
displayed
on the lower
portion
of the display apply to the washer
section.
Diagnostic
codes
displayed
on both the upper and lower portions
of the
display pertain
to the control
system of both the washer
and dryer.
"0 MINUTES"
SHOWING
IN DISPLAY
- This indicates
the cycle
is complete
and the washer/dryer
cannot be operated.
Coins
dropped
or debit inputs during this condition
will be stored
in
escrow
but cannot be used until normal operation
is restored
by
opening
and closing the door. If a door switch
has failed, causing
"0 MINUTES"
to remain in the display after the door is opened
and closed,
it must be replaced
before normal operation
can be
restored.
COLD
START (Initial
first use)
- Washer/dryer
is programmed
at
the factory
as follows:
Washer
11 -minute wash period
1.75 wash price (PD models)
0.00
wash price (PN models)
3 rinses (extra rinse not enabled)
Dryer
5 minutes
per coin for PD models
45 minutes
dry time for PN models
1.50 dry price (fixed cycle with top off - PD
Models)
0.00
dry price (fixed cycle - PN Models)
29
Publicidad
Tabla de contenido
