Watching A Still Picture; Getting Rid Of On-Screen Information - Sony DSC-1024G Manual De Instrucciones

4 Adjust the position of the picture by pressing the CENT
/ / /
◊ √ ı ∫ buttons.
CENT
To deactivate the line doubler
Press the LINE DOUBLER button again to turn off the
indicator of the button. The 31.5k output format is restored.
Notes
• If you press the LINE DOUBLER button when the input
source is not NTSC or PAL or the output format is not 31.5k,
"NOT APPLICABLE" appears on the screen and the LINE
DOUBLER button does not function.
• When the line doubler is activated, the ZOOM, SIZE,
APERTURE and TEST PATTERN buttons do not function.
• When the line doubler is activated, the picture size is the
same as the original one.
• When you use the line doubler function, we recommend the
input source video equipment equipped with the TBC (time
base corrector). If you activate the line doubler for the signal
without the TBC and display the converted signal with a
multi-scan monitor, the picture may disappear due to
disturbance of the sync signal.
50
V CENT

Watching a still picture

When a moving picture is displayed, press the STILL button to
set STILL on the screen to ON. The output signal is displayed
as a still picture. The indicator of the STILL button lights.
STILL
To resume the normal screen, press the STILL button again.
Note
In the still picture mode, only the ON/OFF switch, and the
INPUT SELECT, OUTPUT FORMAT, LINE DOUBLER, TEST
PATTERN, MENU, ENTER and CENT ◊/√ buttons will
function.
If you press any other button, "NOT APPLICABLE" appears
on the screen.

Getting rid of on-screen information

When the indicator of the DISPLAY ON/OFF button is lit, the
information on the operation you performed is displayed on
the screen for a few seconds.
To get rid of the on-screen display, press the DISPLAY ON/
OFF button to set DISPLAY on the screen to OFF.
DISPLAY
ON/OFF
Note
Even if DISPLAY is set to OFF, only the main menu appears
when you press the MENU button.
STILL zON OFF
DISPLAY ON z OFF
35