Troubleshooting Guide - Panasonic EP1017 Instrucciones De Funcionamiento

Silla de masaje para el hogar
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING GUIDE

Before requesting service for this unit, check the table below for the possible cause of the problem. Some
simple checks or minor adjustment on your part may eliminate the problem and restore proper operation. If
you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the
problem, call us at 1-800-338-0552 to locate the servicer near to you.
Problem
Massage does not start.
Kneading massage cannot
be changed immediately to
a rolling massage.
Massage heads do not
reach your shoulders.
It seems as if the massage
heads are at different
heights.
Probable cause(s)
The power cord is not plugged in.
The power switch is at the "off "
position.
The operating lock switch is set to
"lock" position.
During reclining if any force or
resistance is encountered, such as
the chair hitting an obstacle, the
chair may stop for safety.
During operation if the chair
encounters any force or
resistance, the massage heads
stop for safety.
The massage heads must move to
the narrowest position for a rolling
massage.
Your shoulders are too high.
This is because an alternating
tapping mechanism is used. It is
not a malfunction.
Alternating tapping mechanism
Approx. 13/32 in.
(1 cm) at most
Approx. 13/32 in.
(1 cm) at most
When stopped, the misalignment
is approx. 13/32 in. (1 cm) at most.
Suggested remedy
Plug the power cord into an AC outlet
(120 V).
Slide the power switch to "on".
Set the operating lock switch to "open".
Remove any obstacles. If the leg
massage operation indicator lamp on the
controller blinks and the chair stops, turn
off the power switch and then turn on
after 10 seconds. Then, press the
"on/off" button on the controller to start
the massage.
Raise your back slightly from the
massage heads. If all operation indicator
lamps on the controller blink and the
chair stops, turn off the power switch and
then turn on after 10 seconds. Then,
press the "on/off" button on the controller
to start the massage.
Wait until the massage heads reach the
narrowest position.
Shift your waist forward and recline the
chair back.
Press the "tap" button in the manual
operation mode. Then press the "quick
stop" button to turn off the tapping.
Check under the back cushion and
cushion insert pad with your hands to
see whether the massage heads have
stopped in an aligned position. If not,
repeat this process until the massage
heads are aligned when stopped.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido