Technical Specification - Beamz Multi Acis III Manual De Instrucciones

FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty
surrounding can cause greater accumulation of dirt on the unit's optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any
deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small
problem is detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!

TECHNICAL SPECIFICATION

Rated voltage : AC220～240V 50/60Hz
Rated power : 60W
LED : 5 x 3W LED (1x Red, 1x Green, 1x Blue, 1x White, 1x Amber)
8 x 3W LED White
Laser : Red 150mW Green 80mW
Fuse : F10A
Control Signal : DMX signal
Channel : 8 Channels
Function : DMX, Auto, Sound active and Master-Slave.
Dimensions per unit : 245 x 300 x 245mm
Weight (per unit) : 4kg
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be
changed without prior notice.