Changing The Temperature Scale; Replacing The Battery - Braun ThermoScan IRT 3020 CO Manual Del Usuario

Temperature taken is
not within typical
human temperature
range (34 – 42.2 °C or
93.2 –108 °F).
If error persists,
If error still persists,
Do you have any further
questions?

Changing the temperature scale

Your Braun ThermoScan is delivered to you with
the Celsius (°C) temperature scale activated. If
you wish to switch to Fahrenheit (°F), proceed as
follows:
Make sure the thermometer is turned off.
Press and hold down the «start» button. After
about 8 seconds the display will show this
sequence: «°C» / «°F» /...
Release the «start» button when «°F» is shown.
There will be a short beep to confirm the new
setting, the thermometer then turns off
automatically.

Replacing the battery

6
HI = too high
LO = too low
System error
Battery is
low, but
thermometer
will still
operate
correctly.
Battery is too
low to take
correct tem-
perature
measurement.
The thermometer is supplied
with one 1.5 V type AAA (LR 03).
For best performance, we
recommend Duracell
batteries. Insert new battery
when the battery symbol
appears on the display.
Open the battery compartment.
Remove the battery and replace
with new battery, making sure
the poles are in the right direc-
tion. Slide battery door back
until it snaps in place.
To protect the environment, dispose of
empty batteries at appropriate collec-
tion sites according to national or local
regulations.
Make sure the probe tip
and lens are clean and a
new, clean lens filter is
attached. Make sure
the thermometer is
properly inserted.
Then, take a new tem-
perature.
Wait 1 minute until the
thermometer turns off
automatically, then turn
on again.
... reset the thermo-
meter by removing the
battery and then
replacing it again.
... call Braun Infoline
(see page 2).
Insert new battery.
Insert new battery.
Call Braun Infoline
(see page 2).
®
alkaline