VGE Blue lagoon Serie Manual De Instrucciones página 7

indicate the value it had at the time it was switched off earlier. If you had increased or reduced the
value of the time meter yourself, the display will indicate the latest counter reading it had before it
was switched off.
The settings of the time meter can be modified if you wish. This is carried out as follows:
After holding down the switch (R) underneath the display for 5 seconds, the display will show "rSt",
to indicate that the user menu has been selected. Once the switch (R) has been released, the meter
indication and "rSt" will blink alternately on the display. By briefly pressing the switch again, it is now
possible to step through the menu options. There are 3 available setting options in the menu: "rSt"
"up" and "dn".
• "rSt" means (reset): This option enables you to reset the meter indication to the factory setting
of 9000 hours. This selection is confirmed if the meter indication and "rSt" on the display blink
alternately. If you hold down the switch (R) for 5 seconds, after which the meter indication 9000
will be displayed, and then release it, the time meter will start counting down from the 9000
hour value. This selection is used if, for example, you have replaced the lamp, or if you have
modified the meter indication yourself and you want to return it to the factory settings.
• "up" means (up): This option enables you to increase the meter indication to the desired hour
indication. This selection is confirmed if the selected user setting "up" and the meter indication
on the display blink alternately. Following this, press the switch (R) down for 5 seconds. After 5
seconds, the display will only indicate "up". You can then release the switch. By briefly pressing
the switch , the counter value can now be increased in steps of 500 hours from the value of
9000 up to a maximum value of 9999. The increased value and "up" will blink alternately on
the display. After you have selected the desired hour indication, wait for 10 seconds. After 10
seconds, the selected hour indication will be displayed and the timer will start counting down.
If you make a mistake while increasing the meter indication, it is possible to reset the counter to
9000 by keeping the switch pressed down for 5 seconds. The counter value will then be reset to
9000, and a new value can be set.
• "dn" means (down): This option enables you to decrease the meter indication to the desired
hour indication. This selection is confirmed if the selected user setting "dn" and the meter
indication on the display blink alternately. Following this, press the switch (R) down for 5
seconds. After 5 seconds, the display will only indicate "dn". You can then release the switch.
By briefly pressing the switch , the counter value can now be decreased in steps of 500 hours
from the value of 9000 down to a minimum value of 0000. The decreased value and "dn" will
blink alternately on the display. Once you have selected the desired hour indication, wait for 10
seconds. After 10 seconds, the selected hour indication will be displayed and the timer will start
counting down. If you make a mistake while decreasing the meter indication, it is possible to
reset the counter to 9000 by keeping the switch pressed down for 5 seconds. The counter value
will then be reset to 9000, and a new value can be set.
UV-C and Pool equipment
BLUE LAGOON UV-C TIMER 40W, 75W & 130W AMALGAM |
EN
7