Preparation Of The Dishes; Selecting The Wash Cycle - ASBER EASY-500 Serie Manual De Instrucciones

asberprofessional.com
The machine you have purchased is fitted with a safety thermostat on the boiler, so that, if the main
thermostat fails, the safety thermostat is able to disconnect the boiler heating.
6.1.3

Preparation of the dishes

Before washing the dishes, the preparatory steps below should be followed:
6.1.4

Selecting the wash cycle.

Before starting the wash cycle, place the corresponding basket containing the dishes in the machine.
Before starting the wash process, the position of the control switch must be changed, or the pre-
selected wash time is maintained when the machine is switched on. Each wash cycle corresponds to
a wash time that should be selected according to the user requirements. Then close the door and
press the start cycle button. Figures 8, 9, 10 and 11 show the different positions of the wash cycle se-
lector switch. Please refer to the correct model.
6.1.4.1 Thermo stop
The machine you have purchased is not fitted with the thermo-stop function. This is only fitted in
higher ranges.
47 asberprofessional.com
During the first heating of the day, the boiler may reach a higher
temperature than that mentioned above due to heating inertia. This is
normal. If pressurised steam is observed coming out of the rinse
branch nozzles, while the boiler is heating, the technical service should
be notified.
Remove the largest pieces of waste from the dishes before placing them in the baskets.
Wash glassware first.
Put the plates in the rack basket.
Place the glasses upside down.
Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.
Place the cutlery baskets in the lower baskets.
The door must be closed for the machine to start the wash cycle. For
safety reasons, if the door is open, the wash cycle will not fill.
ENGLISH