Preparation Of The Dishes; Selecting The Wash Cycle - ASBER TECH-500 Serie Manual De Instrucciones

asberprofessional.com

14.1.3 Preparation of the dishes

Before washing the dishes, the preparatory steps below should be followed:
•
•
•
•
•
•

14.1.4 Selecting the wash cycle.

Before starting the wash cycle, place the corresponding basket containing the dishes in the machine.
To start the wash process first close the door and then select the wash cycle you wish to run for 1.5 s.
The wash cycle will start automatically. Each wash cycle runs for a set time that is selected according
to how dirty the plates are. The cycle times are the same for all the TECH models.
14.1.4.1 Thermo‐stop
The thermo-stop guarantees a constant rinse at a temperature of 85 ⁰C. This means that the machine
continues washing until the boiler reaches the ideal temperature. Then the rinse cycle starts.
45
asberprofessional.com
Remove the largest pieces of waste from the dishes before placing them in the baskets.
Wash glassware first.
Put the plates in the rack basket.
Place the glasses upside down.
Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.
Place the cutlery baskets in the lower baskets.
Short cycle: 60 seconds
Medium cycle: 90 seconds
Long cycle: 180 seconds
The door must be closed for the machine to start the wash cycle. For
safety reasons, if the door is open, the wash cycle will not fill.
If the mains water temperature is less than 50 ⁰C, the installation of
this system may reduce the wash capacity of the dishwasher.
PRESS FOR 1.5 s
PRESS FOR 1.5 s
PRESS FOR 1.5 s
ENGLISH