Berthoud Vermorel 3000 Electric Manual De Instrucciones página 13

6 - RESTARTING AFTER WINTERING:
1. Recharge the sprayer battery.
2. Rinse the circuit by spraying 2 to 3 liters of clean
water, check that there are no leak at each
junction.
3. The sprayer is ready for use. See chapter 4.
7 - NOZZLE REPLACEMENT OR
DISASSEMBLING DURING SPRAYER USE:
1. During nozzle disassembling, the user shall
imperatively keep his personal safety equipment
(gloves, goggles...).
2. Unscrew the nozzle of the nozzle support and
rinse the nozzle immediately.
3. Be careful, the liquid contained in the tube could
spill. Don't press the trigger.
4. Screw the new nozzle or the clean nozzle.
5. Use only the Berthoud nozzle (see the figure).
Nozzle
Nozzle support
ENGLISH
8 - USABLE NOZZLES
VERMOREL 3000 "ELECTRIC" is characterised by
an operation at
regardless of the battery charge level. The FLOW
RATE and PRESSURE values are selected
EXCLUSIVELY using the Selector button
Fungicide
HP
Insecticide
Non-
selective
herbicide
Selective
herbicide
Recommended
Impossible
Every time the nozzle is changed, you
must switch your machine off and then
on again so that it recalibrates itself.
CONSTANT PRESSURE,
(Fig. 6).
BOOM
LP LP
LP