Setup - Step 2 - Kanto AVS SERIE Manual Del Usuario

Step 2: Mount Wall Plate(s)
Wood Stud Wall
If possible, mount the wall plates to a wood stud . Use a
stud sensor to locate the stud, clearly marking the outer
edges of the stud .
Pre-drill the upper hole in the center of your stud, and
attach the wall plate temporarily to the wall using M6 x
50mm screw (A), as shown in Diagram D . Use a level to
ensure the wall plate is vertical, then mark the bottom
hole . Remove the wall plate and pre-drill the bottom
hole . Make sure the wall plate is flat against the wall
surface . Attach the wall plate using two M6 x 50mm
screws (A), taking care not to over-tighten .
Subsequent wall plates can be added by inserting tab,
checking vertical, marking, pre-drilling and attaching .
B
A
Diagram E
Drywall
The AVS series can be mounted to drywall . Use a wall
plate as a template and mark two holes at your desired
height . Use a level to ensure the holes are vertical .
Pre-drill two holes, and screw a Drywall Anchor (E) into
each of the holes flush with the drywall surface . Attach
the wall plate using two #8 x 35mm Phillips screws (C)
and washers (D), as shown in Diagram F . Take care not to
over-tighten .
Subsequent wall plates can be added by inserting tab,
checking vertical, marking, pre-drilling, screwing in
Drywall Anchor (E) and attaching .
CAUTION
Make sure the supporting surface will support
the load limits outlined in the Caution at bottom of
page two . Tighten screws until the Wall Plate is snug flat
against the wall . Do not over tighten screws (A) or (C) .
Each screw should be screwed into a wood stud .
English
6
A
Brick or Concrete Wall
For brick or concrete installations, use a wall plate as
a template and mark two holes at your desired height .
Adjust the wall plate position to be clear of mortar joints .
Use a level to ensure the holes are vertical .
2" (50 mm)
Pre-drill two holes, and insert a Concrete Anchor (B) into
each of the holes flush with the concrete wall surface and
not flush with the surface covering, such as drywall .
3/8"
(10 mm)
Attach the Wall Plate using two M6 x 50mm screws (A),
as shown in Diagram E . Make sure the Wall Plate is flat
against the wall surface . Do not over-tighten screws (A) .
Subsequent wall plates can be added by inserting
tab, checking vertical, marking, pre-drilling, inserting
Concrete Anchors (B) and attaching .
2 .5" thick . Make sure the anchor is seated completely
flush with the concrete surface even if there is another
layer of material, such as drywall . If drywall is over 5/8"
thick custom lag bolts must be used . Concrete must be a
minimum of 2000psi in density .
Diagram D
E
D
C
Diagram F
CAUTION
Make sure the concrete or brick wall is at least
Supporting your digital lifestyle
2" (50 mm)
1/8"
(4 mm)
™