Deck Selection - TECshow DMC-2000 Manual De Usuario

Effect selection
1. FX ON/SEL button
Press to turn the effect on and off on each Deck (SHIFT) +
Press to select the desired effect,
2. FX 1/2 knob
Rotate it to adjust the effect's parameter 2.

deck selection

1. PLAY/PAUSE button
Use this play/pause tracks.
2. CUE button
This is used to set, play and call out temporary cue points.
• When the (CUE) button is pressed while pausing, the
temporary cue piont is set.
• When the (CUE) button is pressed during playback, the
dmC-2000
ENGLISH VERSION
track returns to the temporary cue ponints and pauses
• When the (CUE) button is pressed and held after the
track returns to the temporary cue point, playback con-
tinues as long as the button is pressed in.
3. SHIFT button
When another button is pressed while pressing the (SHIFT)
button, a diffetent function is called out.
4. SYNC button
The tempos (pitches) and beats grids of tracks on multiple
decks can be synchronized automatically.
5. SCRATCH button
Turns scratch mode on or off. If scratch mode is on, the button
will light up and the center part of the jog wheel will scratch
like a turntable when you spin it. If scratch mode is off, the
center part of the jog wheel will pitch bend when you spin it.
6. KEY LOCK button
Turn the key lock function on and off.
7. PITCH BEND -button
Push the automatically lower the pitch down from the exist-
ing pitch setting.
8. PITCH BEND + button
Push to automatically raise the pitch up from the existing
pitch setting.
9. PITCH slider
Use this to adjust the track playing speed.
10. Jog Wheel
When the scratch mode is on the scratch operation is posible.
When the scratch mode is off, the pitch bend operation (ad-
justment of the playing speed) is possible.
11.HOT CUE mode button
Set the hotcue mode.
12. LOOP mode button
Set the auto loop mode
13. SAMPLER mode button
Set the sampler mode
p. 7