Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL TE-TC 920 UL Manual De Instrucciones

8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Remove dust and dirt from the machine at
regular intervals. Cleaning is best carried out
with a rag or brush.
•
Never use caustic agents to clean plastic
parts.
•
The trough (3) and the cooling water pump
(13) must be cleaned at regular intervals or
proper cooling of the diamond cutting wheel
(2) will not be guaranteed.
8.2 Maintenance
Lubricate all moving parts at regular intervals.
8.3 Transport (Fig. 17)
•
Empty the water container before you trans-
port the equipment.
•
If you want to move the equipment to a diffe-
rent location, first undo the clamping screws
(12) and push them together with the machi-
ne head to the same side as the transport
wheels (19), then fasten the two clamping
screws (12) again.
•
Fold up the legs (1) one after the other, star-
ting ideally on the same side as the transport
wheels (19) in order not to overload the trans-
port handle (18) when putting the equipment
down.
•
You can now transport the equipment by the
transport handle (18).
•
You can park the equipment in minimum
space as shown. When doing so, put your
foot on the axle to prevent the equipment
rolling away.
•
Important! Secure the equipment with a strap
if you store it as shown in Fig. 17.
8.4 Fitting/removing the laser (Fig. 19/20)
Remove the laser as shown in Fig. 19/20 before
cleaning the equipment with water.
Anl_TE_TC_920_UL_SPK7.indb 25 Anl_TE_TC_920_UL_SPK7.indb 25
GB

8.5 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 25 -
24.10.2016 16:29:23 24.10.2016 16:29:23