Work Helpers - Makita 2705 Manual De Instrucciones

OPERATION
CAUTION:
Always use "work helpers" such as push sticks and
•
push blocks when there is a danger that your
hands or fingers will come close to the blade.
Always hold the workpiece firmly with the table and
•
the rip fence or miter gauge. Do not bend or twist it
while feeding. If the workpiece is bent or twisted,
dangerous kickbacks may occur.
NEVER withdraw the workpiece while the blade is
•
running. If you must withdraw the workpiece before
completing a cut, first switch the tool off while
holding the workpiece firmly. Wait until the blade
has come to a complete stop before withdrawing
the workpiece. Failure to do so may cause
dangerous kickbacks.
NEVER remove cut-off material while the blade is
•
running.
NEVER place your hands or fingers in the path of
•
the saw blade. Be especially careful with bevel
cuts.
Always secure the rip fence firmly, or dangerous
•
kickbacks may occur.
Always use "work helpers" such as push sticks and
•
push blocks when cutting small or narrow
workpieces, or when the dado head is hidden from
view while cutting.

Work helpers

Push sticks, push blocks or auxiliary fence are types of
"work helpers". Use them to make safe, sure cuts
without the need for the operator to contact the blade
with any part of the body.
NOTE:
For your convenience a push stick has been
•
provided with the tool.
Push stick
19mm
(3/4")
1
400mm
(15-3/4")
38mm
6.35mm
(1-1/2")
(1/4")
6.35mm
6.35mm
(1/4")
(1/4")
008756
Make the push stick using a piece of 1" x 2" as shown in
the figure.
1. Workpiece end
2. 45 ﾟ notch
2
Push block
300mm(12")
120mm
(4-3/4")
6mm
1
(1/4")
2
130mm
(5")
9.5mm
3
(3/8")
50mm
(2")
006219
Use a 19 mm (3/4") piece of plywood.
Handle should be in center of plywood piece. Fasten
with glue and wood screws as shown. Small piece 9.5
mm x 8 mm x 50 mm (3/8" x 5/16" x 2") of wood must
always be glued to plywood to keep the blade from
dulling if the operator cuts into push block by mistake.
(Never use nails in push block.)
Auxiliary fence
19mm
9.5mm
(3/4")
(3/8")
1
460mm
(18")
006211
Make auxiliary fence from 9.5 mm (3/8") and 19 mm
(3/4") plywood pieces.
Wood facing (rip fence)
006165
13
1. Face/edge
parallel
2. Handle
3. Wood screw
130mm(5")
4. Glue together
50mm(2")
50mm
(2")
100mm
4
(4")
8mm(5/16")
1. Face/edge
120mm
parallel
(4-3/4")
40mm
(1-1/2")
140mm
(5-1/2")
1. No. 10 wood
screws (long
enough to
penetrate
halfway into
facing)
1