Error Codes - McCulloch Li 58V 2.5CGR Manual De Usuario

NOTE: The battery pack charger must be connected to the voltage and frequency
1 Insert the power cord into the inlet on the charger.
2 Insert the plug of the power cord in a grounded socket. The LED on the battery
3 Insert the battery pack into the battery pack charger. The green charging light
on the charger is lit when the battery pack is connected properly to the battery
pack charger.
4 When all LEDs on the battery pack are lit, the battery pack is fully charged.
Charge the battery pack for max. 24 hours.
5 To disconnect the battery pack charger from the wall socket, pull the plug. Do
not pull the power cord.
6 Remove the battery pack from the battery pack charger.
• Make sure the battery pack and battery pack charger are clean and that the
terminals on the battery pack and the battery pack charger are always clean and
dry before the battery pack is placed in the battery pack charger.
• Keep the battery pack guide tracks clean. Clean plastic parts with a clean and dry
cloth.
Troubleshooting the battery pack charger during charging:
LED
Error LED is lit
• Symbols on the product or the package show that this product cannot be made
domestic waste. It must be sent to an applicable recycling location for the
recovery of electrical and electronic equipment.
• Make sure to discard the product safely and correctly. This helps prevent a
possible negative effect on the environment and other persons. For more
information about recycling this product, speak to your municipality, your domestic
waste center or the shop from where you purchased the product.
MAINTENANCE

ERROR CODES

Possible faults
Faulty battery pack
Faulty charger
DISPOSAL
Possible step
Contact your service agent.
A solid red warning LED on the
product indicates a faulty charger.
Disconnect the battery pack
charger from the wall socket for
approximately 2 minutes.
Connect the product to the wall
socket. If the warning LED is
still solid, send the product to an
authorized service workshop.
5