Repeat Playback - Roadstar PCD-495MP Manual De Instrucciones

CD/MP3 PLAYBACK
1. Connect the earphones (included) or optional headphones into the Phones jack.
2. Press the Door Open button (15) to open the CD compartment door.
3. Insert a disc with the label side facing up.
4. Close the CD compartment door until a click is heard.
5. Set the VOLUME control (13) to minimum.
6. Press the PLAY/PAUSE button (6), the unit power will turn on automatically and show the
number of the tracks.
IN CASE OF CD DISC
The total number of tracks and total playing time appear on the display: Playback starts.
During playback, the actual track and the elapsed time appear.
IN CASE OF MP3 DISC
The total number of albums and tracks, and MP3 appear on the display: Playback starts.
During playback, the actual album number, track and the elapsed time appear.
CD + MP3
7. Adjust the VOLUME control to your desired listening level.
8. To stop playback temporarily, press the PLAY/PAUSE button (6) once. The elapsed time
will flash and track number compare on the display. Press the PLAY/PAUSE button
again to resume playback.
9. To stop playback, press the STOP (9) button once.
10. To turn the unit off, press the STOP (9) twice.
Notes:
• When the CD door is accidentally opened during playback, "Open " will appear on the
display.
• Wait until the disc is fully stopped before pressing the OPEN (15) button.
• This unit can play 3" (8cm) single CDs without an adaptor.
Playback information
• If a CD Rewritable (CD Recordable) is not recorded properly, "DISC" is displayed.
For CD Audio, use FINALIZE on your CD recorder to complete the recording.
• Playback will stop if you open the CD lid.
• If there is no activity for 10 seconds, the set will clear the display, and if there is no activity
after another 50 seconds, the set will switch off automatically to save energy. Any settings
PCD-495MP_EN.pmd 3
5 6
English
like program and playing modes will be then lost.
LOCATING A PARTICULAR TRACK OR POINT OF THE TRACK
IN CD/MP3
1. Press the BACKWARD ( ) (10) button once to go back to the beginning of the current
track.
2. Press the BACKWARD( ) button repeatedly to go back to previous tracks.
3. Press the FORWARD () (7) button repeatedly to go to next tracks.
4. Press and hold either FORWARD () or BACKWARD ( ) button to search backwards
or forwards, at high speed, a particular point of track.
Note: Low level audio will be heard during the search process to assist in locating the correct
Searching and selecting an MP3 track/album
The following table shows the different functions available when playing Audio CD or
MP3 CDs.
Single file is displayed when playing an MP3 CD with only a root directory which
•
contains no additional albums (folders).
With albums means a MP3 CD with more than one album (folders), and is shown
•
by directory and a number on the display, as AL 09, AL10, etc.
Function
Track select
Music search
Fast track select
Fast album select
REPEATPLAYBACK
INCD
1. Press the PLAY/PAUSE button (6).
2. To repeat the same track, press the MODE button (2) once. "REP 1" will appear on the
English
point in the track.
CD audio MP3
[ [
[ [
[ [
05/11/2013, 18.36
( )
MP3
with multiple albums
[
[
[
[