Blower Feature - Shop-Vac SSP14 Serie Manual Del Usuario

PUMP SET UP AND OPERATION (CONT'D.)
7. Remove outlet-fitting cap located on rear of tank cover. Connect a standard
garden hose onto outlet fitting. Then place other end of garden hose at suitable
drain. The garden hose is not included with your vacuum.
8. Attach the 2½" (6.4 cm) hose to inlet on front of tank.
9. Place wet pick up elbow on the hose end and attach desired accessory to elbow.
Elbow must be in place during pump operation. Do not attempt pump operation
without elbow in place. Do not cover bleed hole in elbow. Failure to follow these
precautions will result in overfilling of unit and misting through exhaust port.
OPERATION
1. Plug the cord into a wall outlet and push the ON switch button.
2. Start vacuuming up the liquid. When there is at least 4" (10 cm) of liquid in the bottom of the tank, the
unit will automatically begin pumping.
3. The unit will vacuum up the liquids faster than the pump removes the liquid from the tank. The unit will
automatically shut off when the tank becomes full.
4. To empty a full tank, remove vacuum hose from the liquid. Do NOT lift the hose to drain the remaining
liquid into the tank. This will cause the unit to overfill and misting through the exhaust port will occur.
5. The ON/OFF switch must be manually held in the ON position for approximately 10 to 15 seconds to
allow the water level to be reduced sufficiently and then pumping will continue automatically. Once the
vacuum is pumping automatically, release the switch and allow it to operate on its own. ATTENTION:
HOLD SWITCH IN ON POSITION ONLY UNTIL WATER STARTS TO FLOW CONTINUOUSLY. RELEASE
SWITCH WHEN PUMPING BEGINS.
6. The unit will continue to discharge liquid until there is about 4" (10 cm) left in the tank. NOTE: If the unit
shuts off before liquid is pumped out repeat steps 5 and 6.
7. When the level of liquid lowers and the unit stops pumping repeat steps 2-7 to continue your cleaning
operation.
8. After the cleaning job has been completed, allow the liquid to be pumped until unit has stopped
pumping. There will be about 4" (10 cm) of liquid remaining in tank.
9. Make sure unit is in the off position. Disconnect plug from the wall receptacle and remove tank cover.
10. Remove and clean pump pick up assembly
11. Empty remaining liquid from tank. Before storing the vacuum or using for dry pick up, clean and dry the
interior of the tank and the underside of the tank cover. Clean and allow the foam sleeve to dry.
Your vacuum can be used as a powerful blower. To use the blower feature, clear the hose of any debris or
obstructions.
For vacuums with a blower port cover (not standard on all models), unscrew blower port cover located
on the back of tank cover. The blower port cover is equipped with a retaining strap to prevent loss of the
cover. NOTE: For maximum performance when vacuuming, remove the blower port cover.
Insert machine hose end into blower port located on the back of the tank cover.
Twist the hose end slightly to tighten the connection. Caution should be used when using
as a blower due to the powerful force of air when using certain attachments.
WARNING
DEBRIS FROM BEING BLOWN OR RICOCHETING INTO THE EYES OR FACE WHICH CAN RESULT
IN SERIOUS INJURY.
PAGE 10

BLOWER FEATURE

–
ALWAYS WEAR EYE PROTECTION TO PREVENT ROCKS OR