AEG MRC 4159 P Instrucciones De Servicio página 67

Power Supply
1. Make sure the grid voltage corresponds to the figures on the rating plate.
2. Plug the power supply unit into a properly installed protective contact socket.
3. Connect the device with the power supply unit by plugging the jack of the power
supply unit into the "DC
CAUTION:
• This device should only be used with the mains supply unit (included). Do not
use it for other devices.
• Only use a 5 V power supply unit (
the device.
NOTE:
• Disconnect from mains power supply during longer periods of non-use.
• If you did not insert another reserve battery, the time and the station memory
will be lost as soon as the power supply is interrupted.
Inserting the Reserve Batteries
(Batteries are not included in the scope of delivery)
In case of power failure or if the power supply unit is pulled from the plug, the settings
are maintained if the reserve batteries are inserted.
1. Open the battery compartment lid on the back.
2. Insert two type AAA / R 03 1.5 V batteries. Check that the polarity is correct (see
battery compartment).
3. Close the battery compartment.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. Danger of explosion!
CAUTION:
• Batteries can leak battery acid. If the device is out of use for a long period of
time, remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Batteries are not to be disposed of together with domestic wastes. Dispose of
the used batteries at the relevant collection bin or at your dealer' s .
MRC4159P_IM
5V " jack.
). A different supply unit may damage
English
67
05.04.17