Back View RV-250 Instrucciones De Montaje página 41

General installation instructions!
Please observe the following points before attaching the outside camera:
–For a reasonable angle of view the outside camera should be attached at a
height of at least 2m.
–The assembly place of the outside camera must offer sufficient firmness
(e.g. branches brushing against the vehicle roof get caught in the
camera).
–The camera must be attached horizontally and concentrically at the rear
of the vehicle (see
The camera cable must be installed in such a way that you can reach
easily the plug connection between camera and connection cable when
possibly removing the camera. The disassembly is thereby substantially
simplified.
The safest type of attachment is provided by screws being put through the
construction, whereby some points are to be considered.
1. Is there enough free space for the assembly behind the selected
position?
2. Each breakthrough must be protected by appropriate measures
against an inrush of underground water (e.g. by inserting the screws
with sealing compound and/or washing off the external mounting
brackets with sealing compound).
3. Does the construction at the attachment place offer sufficient firmness
so that the camera holder can be tightened firmly enough?
If you are not quite sure about the assembly place selected by you, inquire
the construction's manufacturer or its agency.
Hold the camera holder at the selected assembly place and
mark at least 2 different drilling points (see
When fastening with sheet metal screws
The fastening with sheet metal screws may only be made on sheet
steel with a minimum thickness of 1.5 mm.
The following is to be considered when executing drill holes in the
metal plate.
A5_921-02 -GB- RV 250 neu.p65
Assembly of the outside camera
G 3).
41
G 6).
18-09-2003, 11:30
41