Dometic PERFECTVIEW VT 150DIG Instrucciones De Montaje página 12

Installing the radio link
Measuring ruler (fig. 1 5, page 3)
•
Hammer (fig. 1 6, page 3)
•
Centre punch (fig. 1 7, page 3)
•
To establish and test the electrical connection, the following tools are required:
Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
•
Crimping tool (fig. 1 10, page 3)
•
Insulating tape (fig. 1 11, page 3)
•
•
Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and cable binders.
6.2 Installing the modules
!
CAUTION!
Select the location of the modules so that they cannot injure the passengers in the
vehicle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
•
Install the modules so that as few objects as possible are between them.
Metal objects in particular can hinder radio transmission.
•
If possible, install the modules in the vehicle.
The housings are splash-water protected and can be mounted outside the vehicle. In this
case, you need to select a location that is protected against mechanical impacts (e.g. flying
stones).
•
The installation location should be flat.
•
Before drilling, check each time that there is sufficient space on the other side for the drill head
to emerge (fig. 2, page 4).
•
Transmitter module: Make sure you can lay the connection cable to the camera.
•
Receiver module: Make sure you can lay the connection cable to the monitor.
I
NOTE
Pictures and sound are sent from the transmitter module to the receiver module. To
ensure flawless functioning, you need to check whether the wireless transmission is
stable before final installation.
To perform the installation, proceed as follows:
➤ Attach the modules temporarily to the planned installation location.
➤ Install the rear view video system if you have not already done so.
➤ Start up the rear view video system.
12
VT150DIG
EN