Dometic Heki 3 Plus Instrucciones De Montaje página 9

Ocultar thumbs Ver también para Heki 3 Plus:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
Heki3 Plus
Dismantling the lamps
➤ Remove the connection cable (B).
➤ Remove the holders on the short side (C).
Preparing the lamps for installing on the long side
➤ Insert the holders in the openings provided on the long side (D).
➤ Lay and attach the wiring harness on the back again.
➤ Connect the cables (E).
See fig. c
➤ Insert the appropriate adapter part for the roof thickness (1) for the hand crank on
the drive sprocket:
Wall thickness
25 – 32 mm
33 – 39 mm
39 – 46 mm
46 – 53 mm
53 – 60 mm
➤ Put the hand crank (2) to the closed position.
See fig. d
A
NOTICE!
• Hold the hand crank in the closed position when placing the inner
frame on the outer frame, otherwise the position of the hand crank
will be misaligned with the hexagon part.
• Make sure that the power supply line from the vehicle is inserted in
the inner frame openings and does not get stuck.
➤ Place the inner frame on the outer frame and fasten it with the fastening screws
∅ 2.5 x 12 mm in the 16 mounting supports.
To do this, use the small holes in the mounting supports.
Only fasten the screws slightly by hand.
➤ Check that the roller blinds can move freely.
If they do not, then loosen the screws slightly.
EN
Adapter part colour
Grey
Black
Yellow
Blue
Red
Installing the Heki3 Plus
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido