Dometic Heki 3 Plus Instrucciones De Montaje página 10

Installing the Heki3 Plus
See fig. e (cross side installation)/fig. b (long side installation)
➤ Insert the lamps into the holders (F).
See fig. f
I
NOTE
If the vehicle switch is designed for this, both lamps can be switched on
and off separately.
If you want to connect the lamps:
➤ Connect the cable from both lamps to the 1 and 2 terminals.
If you operate both lamps on one connection, you have to connect the two
terminals in parallel with bridges.
➤ Tighten all 12 V connections.
➤ Make sure the lamps are fitted securely.
See fig. g
When you have connected the lamps:
➤ Clip on the ventilation grille (1).
It needs to click in.
➤ Clip the lamp covers (2) on the lamps.
They need to click in.
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ After installing, check the roof light works properly.
➤ If necessary, enter the new vehicle height and weight in the vehicle documents.
10
Heki3 Plus
EN