Dometic MAGICCOMFORT MSH300 Instrucciones De Montaje página 16

Installing the seat heater
Preparing the heating elements
A
NOTICE!
Insulate all the trimmed ends with the insulating material supplied to
prevent a short circuit.
I
NOTE
• You can cut the heating elements to the required length and shorten
the lengths of the two conductor paths.
• You can cut out a section of the heating element in the area of the
anchoring grooves on the seat or the backrest. Make sure the cut-out
sections are only made between the two black seams (fig. 5,
page 4).
• Do not cut the mat lengthways, otherwise it will not be heated in the
area of the incision (fig. 5, page 4).
• The heating surface on the backrest only needs to extend approx.
30 – 35 cm above the seat, as the driver only leans against this area
when sitting normally (fig. 6, page 4).
➤ Place the heating elements on the seat and backrest.
➤ If there are anchoring grooves in the seat or the backrest, mark these areas on the
heating elements.
➤ Mark the required lengths. Take into account the depth of the anchoring
grooves, if present. The heating element is inserted in these anchoring grooves.
➤ Trim the heating element to the required length.
➤ Customise the cut-out sections as required.
➤ Insulate all the trimmed ends with the insulating material.
16
MSH300, MSH301
EN