Angle Mark; Osd Language - Brandt BDVDP9210 Manual De Uso

2. Press to select "GENERAL SETUP PAGE".
TV DISPLAY:
Set the aspect ratio of the DVD Player according to the TV you have
connected.
1. Press ▲▼repeatedly to highlight TV DISPLAY.
2. Enter its submenu by pressing .
3. Press ▲▼repeatedly to highlight the selected item.
4. Press to confirm.
4:3 4:3 PANSCAN PANSCAN
4:3 4:3 PANSCAN PANSCAN
→ If you have a normal TV and want both sides of the picture to be
trimmed or formatted to fit your TV screen.
4:3 4:3 4:3 L L L L ETTERBOX ETTERBOX ETTERBOX
4:3 ETTERBOX
→ If you have a normal TV and select the item, a wide picture with
black bands on the upper and lower portions of the TV screen will be
displayed.
16:9: 16:9: 16:9: 16:9: Wide screen display
Wide Squeeze
Wide Wide Wide Squeeze Squeeze Squeeze: To set display mode to 4:3.

ANGLE MARK:

It displays current angle setting information on the display, if available
on the disc.
1. Press ▲▼repeatedly to highlight ANGLE MARK.
2. Enter its submenu by pressing .
3. Press ▲▼repeatedly to highlight the selected item.
On: On:
→ On: On: Enable Angle Mark.
→ Off: Off: Off: Disable the current angle setting display. Off:
ENTER
4. Press ENTER ENTER ENTER to confirm.

OSD LANGUAGE:

You can select your own preferred language settings. This DVD system
will automatically switch to the selected language whenever you load a
disc. If the language selected is not available on the disc, the disc's
default language will be used instead. The OSD language in the system
menu will remain once selected.
1. Press ▲▼ repeatedly to highlight OSD LANGUAGE.
2. Enter its submenu by pressing .
17