Before Using The Equipment; Operation - EINHELL PRESSITO Manual De Instrucciones

5. Before using the equipment

Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to the supply voltage (if operating
from the mains power supply).
Before you connect the equipment to the power
supply make sure that the data on the rating pla-
te are identical to the data for the rechargeable
battery (if using a rechargeable battery for ope-
ration).
•
Check the equipment for damage which may
have occurred in transit. Report any damage
immediately to the transport company which
was used to deliver the compressor.
•
Make sure that the intake air is dry and dust-
free.
•
Do not install the compressor in a damp or
wet room.
•
The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5 °C to 40 °C). There must
be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
•
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with spray-
ed water.
•
Operate the equipment only on a firm, level
surface.
Warning! When using the equipment to infl ate
objects, check the information and safety instruc-
tions provided by the manufacturer.
5.1 Charging the LI battery pack (Fig. 2, 9)
1. Remove the battery pack (6) from the handle,
pressing the pushlock button (a) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(d) into the socket outlet. The green LED will
then begin to fl ash.
3. Push the battery pack (6) onto the battery
charger (d).
Anl_PRESSITO_SPK9.indb 23 Anl_PRESSITO_SPK9.indb 23
GB
In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit.
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
5.2 Battery capacity indicator (Fig. 2)
Press the button for the battery capacity indicator
(b). The battery capacity indicator (c) will indicate
the charge status of the battery by means of 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs fl ash:
The battery pack has undergone exhaustive di-
scharge and is defective. Do not use or charge a
defective battery pack.

6. Operation

6.1 Changing between mains/battery operati-
on and compressor compressed air/low-
pressure blower operation (Fig. 7)
To change over between mains-powered and
battery-powered operation, press the selector
switch (10):
•
DC/switch to the right:
•
The equipment will be supplied with power
from the rechargeable battery.
•
AC/switch to the left:
•
The equipment will be supplied with power
from the power cable.
•
To change over between compressed air and
low-pressure operation, press the selector
switch (12):
•
Switch to the left: Compressed air operation
- 23 -
01.09.2017 11:02:18 01.09.2017 11:02:18