Adjusting The Charging Current Distributor; Dsp-T24); Using The Dc Kit; Switching On The System - Dometic DC-Kit PP 12 Instrucciones De Montaje

DC-Kit PP12, DSP-T12/24
7.7

Adjusting the charging current distributor

(only DC-Kit PP12/DC-Kit DSP-T24)
A
NOTICE!
The following work must be carried out with caution and only by persons
with the necessary skills and knowledge. This is because incorrect
adjustment of the switch-on and switch-off voltages can cause the air
conditioner to malfunction and may cause the vehicle's electrical system
to fail.
I
NOTE
The voltage scale shown on the charging current distributors is a guide.
If different values are set, these must be checked using a suitable voltage
measurement device. An externally adjustable laboratory power supply
can be connected to terminals GND and D+ for this purpose.
➤ Insert a screwdriver into the axis of the potentiometer (fig. 0, page 9).
Turning the axis clockwise increases the voltage threshold value, turning it
counter-clockwise reduces the voltage threshold value.
I
NOTE
We recommend against setting a switch-off voltage below 11.5 V.
8

Using the DC kit

This chapter contains information on operating the overall system. This operating
manual does not replace any information contained in the installation and operating
instructions for the individual components.
I
NOTE
Only DC-Kit 12PP: The operating noises made by the air conditioning
unit are louder during mobile air conditioning than during stationary air
conditioning. The noises are caused by using the inverter.
8.1

Switching on the system

Observe the following instructions before you switch on the system:
• Air the vehicle.
• Make sure that the ventilation slots on the air nozzles and the fan of the compo-
nents are not covered up.
EN
Using the DC kit
23