Technical Specifications Gb - IKRA IGBS 1054 LI Instrucciones De Manejo

Accu Grass- and Shrub shear IGBS 1054 LI
Technical Specifications
Battery voltage/operation voltage
Battery type
Operating time
No-load Speed n
0
Cutting width *
Cutting length **
Cutting thickness **
Weight
Acoustic capacity level
Noise pressure level as per
Vibrations
(DIN EN 60745-2-15)
Mains battery charger
Mains voltage
Charging voltage
Charging current
Charging time
Technical changes are reserved.
* Grass trimmer ** Shrub trimmer
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks.
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
- Always keep hands and feet away from the cutting tools, particularly when switching on the motor!
GB | Operating Instruction
(DIN EN 60745-2-15)
V DC 7,2
Ah / Wh 2,2 / 15,8 / lithium-ion
min. max. 130* / 175**
rpm 1000
mm 75
mm 160
mm 7,8
kg 0,600* / 0,650**
dB(A) 86
dB (A) 58,4
K 3,0 dB (A)
m/s <2,5
2
K 1,5 m/s
V~ / Hz 100-240 / 50-60
V DC 9,6
mA 700
h approx 3 - 5 hours
GB-2
2