MoJack EZ Manual Del Usario página 12

STEP 6
Adjusting Support Rods for Proper Tire Size
• Adjust Support Rods on Wheel Pads to accommodate the front
tire size of the mower. Please refer to the chart below for proper
Support Rod placement based on the diameter of the mower's
front tires.
• Secure Support Rods to Wheel Pads with Large Hair Pins.
SUPPORT ROD GUIDE FOR TIRE SIZES
10" - 11.5"
(25cm - 29cm)
12" - 15"
(30cm - 38cm)
15.5" - 17"
(39cm - 44cm)
See page 18 for more more detailed guide.
STEP 7
Reverse Front Tires of Mower
• In some cases, the mower deck or anti-scalping wheels will hit the
Lift Arm while the mower is being raised. This is often the case if
part of the deck (including the anti-scalping wheels) protrudes past
the center line of the front wheels of the mower.
• Rotate the front tires 180° so that they are in the reverse position.
• Remove the Support Rods from the Wheel Pads and slide the
MoJack EZ underneath the mower.
• Secure the Support Rods to Wheel Pads with Large Hair Pins.
Using the MoJack EZ (Steps 8 - 15)
STEP 8
Move Mower onto MoJack EZ
The MoJack EZ must be used on a solid
level surface.
• Drive or roll the mower onto the Wheel Pads.
Stop engine and remove the key.
MoJack EZ Lift
Operating Instructions
(optional – if not applicable, skip to Step 8)
Large Hair Pin
Forward
Wheel
Position
Reverse
Wheel
Position
12
Support Rod