Annual Inspection; Inspection Procedure - SKYLOTEC Jackpod JP-011-1 TRI 1 Instrucciones De Uso

6.2 Annual Inspection

At least annually, and more frequently if subjected to harsh conditions or excessive use, the Tripod MUST
BE given a detailed inspection by a competent person as described below, and the results recorded in an
EN
Inspection Log. A sample Inspection Log is provided on Page 14 of this manual, please make photocopies
of this sample to record all inspection results.
NOTE: Any time equipment is returned to a factory authorized service center for repair, please provide
photocopies of all previous Inspection Log sheets for that product to assist with diagnosis and processing
of any warranty claims.
Please obtain a Returned Goods Authorization number from the service center before sending your
equipment for service.
6.2.1 Cleaning
Prior to this inspection, clean the exterior surfaces of the Tripod with a mild soap solution on a soft cloth.
Do not use solvents or other chemicals to clean the winch.

6.2.2 Inspection Procedure

Following the instructions contained in Section 6.1.2, inspect the Tripod for physical damage. Record the
results in the Inspection Log.
IMPORTANT: Be sure to review any previous inspection records to be aware of existing concerns and to
allow for re-inspection of any potential problem areas. Cumulative findings may lead to the need for repair
or replacement when looked at together.
7. MAINTENANCE, LUBRICATION and STORAGE
This Tripod has been designed to provide many years of trouble free service, and requires little in the way
of routine maintenance.
Any loose fasteners should be tightened, with the Tripod being sent to a factory authorized service center
for structural repair if necessary.
Basic cleaning should be performed at least annually (as outlined in Section 7.1) as part of the annual
inspection, or more frequently as required when used is under harsh conditions.
7.1 Cleaning the Tripod
Use a solution of warm water and a mild detergent to clean the Tripod and its labels. Do not use solvents
or other cleaners to clean the base, as this may result in damage to the powder coat finish.
7.2 Lubrication
7.2.1 Sky-Klick Lubrication
After cleaning and inspection as instructed in Section 7, apply WD-40® or similar moisture displacing
penetrating lubricant as required, and wipe away any excess with a clean cloth. Do not apply oil, grease,
or other lubricants that may attract and trap contaminants.
22