Adding A Wireless Router - PRESONUS SL-Dante-MIX Option Card Guía De Instalación Y Conexiones

3.2

Adding a Wireless Router

Dante audio and routing cannot travel over a wireless network.
You can still wirelessly remote control your StudioLive AI-
series mixer over a Dante network using UC Surface and
QMix-AI, but you'll have to do a little more setup.
Complete instructions UC Surface can be found in your StudioLive AI-series
Software Manual available from your My PreSonus user account and at
www.PreSonus.com.
NOTE: Installation of the SL-Dante-MIX option card disables the use of
the USB Wi-Fi LAN adapter for StudioLive AI-series mixers. All control
must be done through the Ethernet connections on the option card.
priority. This is especially important if you
are transferring large amounts of data over
your Dante network or if you are transferring
non-Dante data over the same network.
If you are using multiple switches on your
•
Dante network, we recommend using
the same make and model to simplify
setup and guarantee compatibility.
1. To connect a wireless router to your
Dante network, you will need to
purchase a managed switch and dive
into its configuration settings.
2. Select the port to which you've connected
your wireless router and set Multicast
Filtering to "On. " This will stop the flow
of Dante traffic to that port and allow it
to be used for wireless remote control
of your mixer. Do not connect Dante
devices to the ports on a wireless router.
Please consult the documentation that
came with your managed switch for
instruction about enabling Multicast
Filtering on a specific port.
3. Because your mixer is hardwired to the
switch, no additional setup is required
to remote control it from UC Surface.
Simply connect your device to the wireless
router network and launch UC Surface.
SL-AVB-MIX Installation and Hookup Guide
9