Installation On The Wall - Sonnenkraft PSKR18 Manual De Instrucciones

Installation on the wall

Mark fastening points, drill, set anchors, screw in panel
screws, push spacer sleeves onto panel screws.
Put on rear insulation shell, hang station on the panel
screws and fasten with nuts.
Directly connect connections below without corrugated
pipe
Caution!
Counterhold when tightening the union nuts.
Installing safety unit /
Connection for diaphragm expan-
sion tank
The solar safety unit is mounted on the return ball valve
with
- solar safety valve [3],
- connection for diaphragm expansion tank [5],
- flushing and filling valve tap [4],
- pressure gauge [6].
Caution!
Discharge the heat transfer medium escaping at the
safety valve into a collecting vessel via a suitable
pipe.
18 GB