Using The Refrigerator; Energy Saving Tips - Dometic GROUP WAECO CoolMatic Serie Instrucciones De Montaje

CoolMatic
Connecting the refrigerator to AC voltage
D
DANGER! mortal danger!
 Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
 If you are operating your refrigerator on board a boat with an
AC mains connection using a shore connection, you must
install a residual current circuit breaker between the AC mains
supply and the refrigerator.
Seek advice from a trained technician.
Proceed as follows when you connect the refrigerator to the AC supply:
➤ Plug the connector into the AC socket (fig. f 1, page 9).
8

Using the refrigerator

I
NOTE
 Before starting your new refrigerator for the first time, you
should clean it inside and outside with a damp cloth for
hygienic reasons (please also refer to the chapter "Cleaning
and maintenance" on page 52).
 Do not use force to press the flap of the freezer.
 Do not pull out the dividing wall if there is ice in the freezer.
 Do not remove the panel sticker when operating the
refrigerator.
8.1

Energy saving tips

 Choose a well ventilated location which is protected from direct sunlight.
 Allow hot food to cool down first before you put it in the refrigerator.
 Do not open the refrigerator more often than necessary. If the door is left
open for more than 5 minutes, the light starts to flash.
 Do not leave the door open for longer than necessary.
 Defrost your refrigerator as soon as a layer of ice forms.
 Avoid unnecessarily low temperature settings.
 Clean dust and dirt from the condenser at regular intervals.
EN
Using the refrigerator
47