Unpacking; Useful Information - IKA MF 10 Serie Instrucciones De Manejo

• Unpacking

- Please unpack the device carefully
• Delivery scope IKA MF 10
®
The delivery quantity for the drive includes:
an IKA MF 10 drive unit, a collecting pan, a
®
mains cable, a face spanner, an Allen wrench, a
fork wrench and an operator's manual.
The delivery quantity for the impact grin-
ding head includes:
an impact grinding surface with built-on door
and three screwed-in fastening pins, a dosing
sluice, a hammer rotor, a countersunk screw, a
disk, a cover and the fi lter which you ordered.
The IKA MF 10 analytical mill is a continuous-
®
ly operating universal mill. It makes it possible
to use two different grinding methods which
cover the greatest range of all grinding tasks
occurring in the laboratory.
Impact grinding:
Application for hard, brittle and/or dried mate-
rials or ground materials embrittled as a result
of cold (e.g. grain, coffee, coal, etc.).
In this case, the ground material is cut up by
means of rotary beaters and comminuted on
the grinding surface attacherd to the blow
bars. The ground material is broken and ejec-
ted into a suitable collecting pan by means of
corresponding filters. The feed dosage provides
for optimal dosage so that the mill can work
at the optimal operating point. The grinding
chamber is locked so that it is dustproof, the
Unpacking
- In the case of any damage a detailed report
must be set immediately (post, rail or for-
warder)
The delivery quantity for the cutting-grin-
ding head includes:
a cuttinggrinding head with three built-in bed
knives, built-on door, tabular slide valve and
funnel, as well as three screwed-in attaching
pins, a plunger, a blade rotor with three moun-
ted rotor blades, a cheese head screw, a disk
and the fi lter which you ordered.

Useful information

collecting pans are attached with standard
ground joints. Thus the loss ground material is
kept to a minimum.
Cutting-Grinding:
Application for soft fibrous ground material
(e.g. hay, straw, plastic waste, paper, wood,
etc.).
In this case, the ground material is cut between
rotary blades and standing blades attached at
the grinding surface. The ground material is
conveyed into the collecting plan by means of
filters here as well. The feed unid (guide chan-
nel) makes it possible to load awkward, bulky
material. The cutting loads mean that less ener-
gy is introduced into the ground material and
thus results in less heat generation. This keeps
ground material loss to a minimum.
18