Trotec BL 30 Manual De Instrucciones página 16

04 . The display of time and
date changes automatically
every 10 seconds
05 . MAX: Displays the highest
measured value, including
the associated date and time .
06 . MIN: Displays the lowest measured value, including
the associated date and time .
07 . REC: This message appears throughout the entire
measuring procedure
08 . FULL: This message appears if the data memory is
full . No further data can be stored .
09 . %RH: The measured humidity is displayed as a per
centage .
10 . °C: Temperature in degrees Celsius
11 . °F: Temperature in degrees Fahrenheit
12 . Press the MAX/MIN button in order to display the
maximum or minimum values stored during the
recording period . The appliances returns to measu
B - 4
13 . The message „-PC-" appears on the display when
14 . Alarm function: The LEDs flash once per minute
operating instructions - climate data logger Bl30
ring mode after 40 seconds if no further button is
pressed .
transmitting the collected measured data to the PC .
The data logger returns to measuring mode after
data transmission is complete . The currently mea-
sured value is displayed and the recording is stop-
ped . Perform a reset; in other words, prepare the
data logger via the PC software for a new measu-
rement in order to be able to start a new recording
sequence . As a matter of principle, the measured
values can only be read from the display . All settings
in the data logger are performed exclusively via the
software installed on the PC .
in the case of exceeding or falling below the set limit
values . The red LED indicates that the temperature
has exceeded/fallen below the user-selected limit valu-
es . The yellow LED indicates that the relative humidity
has exceeded/fallen below the user-defined limit values .