Modifying The E.base Using The E.base Xt Extension Kit - Minnid e.base XT Instrucciones De Uso

E
N
4 kg
Ø If the e.base XT extension kit is not in use,
remove it by releasing the linchpins.
Ø The two supports that are permanently
bolted on remain on the e.base.
Ø The individual weights of the e.base XT
extension kit must be taken into account
when calculating the permissible payload.
o The remaining parts increase the
weight of the e.base by +4 kg.
o The removable part increases the
weight by +5 kg.
20
6 Modifying the e.base using the e.base XT
extension kit
When using the e.base XT extension kit, the
use of side positioning lights is a legal
requirement.
5 kg
Ø Mount the side positioning light on the
e.base.
Ø Open the cable sheath at this point.
Ø Connect the wires e.g. with a suitable
quick connector clip (driver's side:
white to grey-black, brown to brown
and passenger side: white to grey-red,
brown to brown)
Ø Seal the open area again.
Ø Check that the lights are working
(continuous lights)
o Remove nut.
o Screw on side light.
1.240.233BA_20200302