brennenstuhl ML SN 4005 V2 IP 54 Manual De Instrucciones página 6

Operating Instructions
D
prOpEr INTENDED usE:
This high-power LED lamp is suitable for internal and external lighting (e.g. workshop, camping,
garage, household, etc.). The lamp is not suitable as accent lighting. The LED lamp is delivered,
ready to connect, with a connection cable and plug. It can be used as a power distributor using
the socket on the back (not all models). All models are spray water-resistant. DE and FR plug
variants can only be plugged into outlets with a protection class of IPX4. Please only use the GB
and CH plug variants in dry environments as they are not spray-water-resistant. Another use than
the above or modifying the device is not permitted.
OpEraTION:
setting up and turning on the light
Place the light on a dry, level surface. Only use the lamp with the arm extended. The continuously
adjustable arm can be used to set the lamp at different tilt angles. The light can be turned on and
off using the switch on the back.
Mount the lamp on a tripod
The lamp can be mounted on a suitable tripod with the help of the holes on the mounting
bracket (mounting materials not included!). Make sure the tripod is sufficiently stable and the
light is permanently mounted. The height of the tripod should not exceed 2 m. Depending on
your tripod you may have to unscrew the retaining bracket from the lamp, turn it 180° degrees
and screw it back in.
safETy NOTEs:
1. Prior to commissioning, make sure the right voltage is available.
2. Prior to each use, make sure the light and mains supply cable are not damaged in any way.
Never use the lamp if you find damage.
Caution! a damaged light or mains supply cable pose a risk to life due to electric shock!
3. Do not use this light without properly attached gaskets!
4. Do not use the work lamp in explosive environments in which flammable liquids, gases or
dusts are present. risk to life!
5. LED lights are extremely bright. Do not look directly at the lamp.
6. Damaged protective covers must be replaced with an original Brennenstuhl® protective cover
before the light can be used again.
7. If the mains supply cable of the device is damaged it must be replaced by a qualified technician
in order to avoid risks.
8. Make sure the light is attached firmly and securely.
Make sure the cable is not crimped or otherwise damaged.
9. Never network several lamps. risk to life due to overheating!
10. Keep children away from the lamp. Children cannot estimate the risk of electric shock.
6
BA_Mobile_Compact_LED-Leuchte_ 0488682-15P128_prn.indd 6
Mobile Compact LED Light
31.08.16 15:38