Lubricating The Blades - O'Barber TO30 Manual De Usuario

autonomy.
Charge the battery, refer to § 3.1.
 The clippers can be used with the electrical lead. In this configuration,
connect the cable to the clippers (Fig. 3a) and connect the power pack
(Fig. 1-M) to a mains power socket.
3.3 Adjusting the cutting height
 Move the knurled knob (Fig. 1F / Fig. 4) to select a cutting height: 0.8 –
1.2 – 1.6 – 2.0 mm.
3.4 Using the comb attachments
 The clippers must be switched off. Select a comb attachment: 3, 6, 9 or
12 mm (Fig. 1 refs. I – J – K - L).
 Place the comb attachment on the blades (Fig. 5) and clip it on. When
the comb attachment is correctly fixed, it is immobilized.
 To remove the comb attachment, free its clip by pressing on its rear
part it with your thumb.

3.5 Lubricating the blades

After 30 minutes of use, it is recommended to lubricate the cutters.
 Stop the clippers and place the sliding knob in 2.0 mm position (Fig. 4).
 Removing blades: hold the blades with your thumb and press on the spot shown
by the arrow (Fig. 6a).
 Apply 1 drop of lubricating oil on the points shown (Fig. 6b).
Use only the oil supplied.
 Install the blades by first inserting the rear part (Fig. 6c). Press the blades with
your thumb to clip them in.
 Switch the clippers on for a few seconds after lubricating them.
4 Servicing
4.1 Routine servicing
 After using the clippers each time, clean the blades with the brush
supplied (Fig. 1-H).
 If necessary, clean the body of the clippers with a cloth slightly
dampened with water or mild liquid soap. Never use abrasive products
or solvents.
25
EN