User Manual - Perel 406 Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the
device after its lifecycle could harm the environment. Do not dispose of
the unit (or batteries) as unsorted municipal waste; it should be taken
to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local
environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing
this device into service. If the device was damaged in transit, don't install or use it
and contact your dealer. Refer to the Velleman
on the final pages of this manual.
The digital programmable thermostat is battery operated. It has 7-days preset
programs to suit most of the family's style. It can be easily adjusted to fit your
own living style with few programming steps. The thermostat is operated by 2 X
AA size batteries. It can therefore replay any mechanical standard 2-wire
thermostat. Note that the maximal resistive load is 5 amps.
2. Installation
If you connect the thermostat to a 230VAC system, make sure the power is
switched off and that only a person with good electrical knowledge does the
installation. If you have a mechanical thermostat commented with 2 wires, just
take away the old thermostat and replace it with this thermostat. Connect the 2
wires to the terminals as shown in figure 1 to 3. If you do not have a previous
thermostat that you wish to replace, install a 2-wire cable to the heating system
(see fig. 1 to 3) or consult with your professional electrician. Before installing
thermostat, install the thermostat on the location of the old thermostat:
1. Place the thermostat as following:
a. About 160cm up from the floor on a wall with constant temperature in the
house
b. Only on inside walls (not on a wall towards the outside door)
c. Not exposed to direct sunlight
d. Not close to a heater, furnace or ventilation outlet
e. Not close to a door toward the outside door
2. Remove the front cover; unscrew the screw in the battery compartment.
Remove the front housing of the base.
3. Unscrew the screw in the protective cover and remove the protective cover.
4. Mount the base on the wall and make sure the hole on the wall is covered by the
base with wires coming in through the protective cover hole.
5. Loosen the screw of the terminal block and install the wires into the terminals
20.01.2015
406

USER MANUAL

®
Service and Quality Warranty
©Velleman nv