Setting The Water Temperature - Iberspa 25414 Manual De Funcionamiento

Compact Equipment Manual for residential fitted Spas
SETTING THE WATER TEMPERATURE (0º-40º C)
The temperature is set by the temperature programmer buttons, to increase or decrease the required
degrees.
The Spa temperature can be set within a range from 0º to 40º.
4.3.1. FRONT CONTROLS
Thermostat functions:
In programming, the value displayed increases.
Press for 5 seconds to display the SET POINT temperature.
In programming, the value displayed decreases.
Indicator LEDS:
LED 1:
LED 2:
LED 2 flashing:
Temperature setting
The TEMPERATURE SET POINT is 0ºC by default.
- Press key
flashing.
- Press key
- Press keys
will again indicate the temperature and LED "2" will stop flashing.
Indicating defrosting is on.
Indicating relay is on.
Programming phase
for 5 seconds. The current SET POINT will be displayed and LED "2" will start
or to select the required SET POINT value.
+ simultaneously to set the new value. When this operation is done, the display
11
English .