iSi Soda Siphon Stainless Steel Modo De Empleo página 19

Troubleshooting.
Release the pressure
Place the siphon upright in a sink and gently
operate the lever until the pressure is gone from
the iSi Siphon. Now the head can be removed
from the bottle.
If the pressure will not release, please contact
iSi or your service center.
Soda charger will not puncture.
1. The charger being used is not suitable.
——— Only use original iSi soda chargers.
2. The charger was inserted backwards.
——— Insert the iSi soda charger correctly
(see diagram: Instructions for Use).
3. The puncturing unit has been damaged.
——— Send the siphon to iSi or a service center.
Water does not contain any CO
any at all.
1. The siphon was not shaken enough.
——— After screwing on the iSi soda charger,
shake the siphon vigorously several
times (at least 5 times).
2. The water is not cold enough.
——— The colder the water, the more CO
it can absorb. For the best results we
recommend keeping the filled Soda
Siphon in the refrigerator.
3. No pressure/not enough pressure in the
device.
——— Only use original iSi soda chargers.
——— Do not reuse empty chargers. They
should be recycled.
During operation, water and gas are leaking
through the outlet — pressure-relief valve is
engaged.
1. The siphon was overfilled.
——— "Release the pressure" and refill the
siphon.
——— Observe the maximum filling amounts.
Ensure the measuring tube is fully
inserted before filling.
or hardly
2
11
EN
2