iSi Soda Siphon Stainless Steel Modo De Empleo página 20

2. Too many chargers were used.
——— Pay attention to the maximum number
of iSi soda chargers to be used indicated
in the Siphon Data.
During operation, gas is leaking between the
bottle and the head.
1. The head was not tightened securely.
——— Tighten the head onto the bottle
by hand as per the instructions.
2. Riser tube with gasket was not used.
——— "Release the pressure" and insert the
riser tube in the bottle.
3. The gasket has been damaged.
——— "Release the pressure." The riser tube
with gasket needs to be replaced and
is available as an original iSi spare part.
4. The bottle has been damaged on the upper
edge.
——— "Release the pressure." Send the siphon
to iSi or a service center.
Service.
Replacement parts are available individually
and at an affordable price.
See your specialist dealer for the availability
of replacement parts. In the U.S. replacement
parts are also available at www.isi-store.com
Only send in the complete siphon for repairs.
Replacement parts can be seen in greater detail
on the expanded drawing.
12