Tabla de contenido
Publicidad
NOTE: A slight hissing noise may be heard
when removing the charger holder. This is
normal.
11. Screw the cap onto the thread.
Operation
12. For dispensing, the device must be held „head-
first" (with the decorator tip facing down-
wards!) and the lever must be operated gently.
NOTE: Test the consistency of the contents
when the whipper is first used. Shake the
whipper again if the consistency is still too
runny.
Cleaning.
NOTE: Please observe the illustrations
on cleaning!
1. Press the lever until the whipper is com-
pletely empty and there is no pressure left.
Remove the head from the bottle.
2. Remove the adapter from the dispensing
piston and remove the decorator tip from
the adapter.
3. If the silicone cover was used, remove this
from the iSi bottle by pulling it upwards
and clean by hand using domestic hand dish-
washing detergent.
4. Remove the head gasket and the dispensing
piston for basic cleaning.
5. Clean product components by hand using
warm (max. 50°C) potable water along with
domestic hand dishwashing detergent and
clean the dispensing piston and decorator tip
using the cleaning brush. Completely remove
any traces of fat or egg white.
NOTE: Do not use scouring agents or abra-
sive sponges/brushes.
NOTE: Do not put in the dishwasher and do
not wash in boiling water.
NOTE: The decorator tip can be unscrewed
at any time for periodic cleaning.
10
Publicidad
Tabla de contenido
